Progress on my 64 Fury

["MO ( Steve Mick)" <micher@xxxxxxxxxxxxxxx>]

I got the old beast running better, after cleaning and re-gapping the plugs, 
and tinkering with the Holly carb. I actually  took it out on the road for a 
test drive. After refilling the torque converter, I put in 2 1/2 qt. of 
tranny oil  and it still is low on trans fluid. ( I ran out of more)   It 
still does not run quite rightIt its hard to tune with open headers and 1000 
idle rpm cam. The tranny shifting is erratic I don;t know if it is because 
of being low on TF or because I dont have the shift down linkage hooked up. 
I know I don't like the B&M ratchet shifter! I have located a 65 T  flite 
cable shift tranny locally and it would have the slip yoke output shaft. . 
The Holly accelerator pump barely dribbles in some gas , so I will have to 
experiment with some different acc. pump cams to get a better shot. 
.........................MO
{Steve Mick}
http://stevemick1964dodge.shutterfly.com/pictures/5 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.