RE: '62 rear drums

["Gary H." <spigot2039@xxxxxxxxxxx>]

This is on the 62-65 Tech page:

"Do you need new 11 by 2 1/2 inch rear brake drums for your 1962 to 1965 Mopar? Check out Raybestos® part number 2953 (or another brand drum that crosses to that part number, like Wagner BD60187). [Thanks to Bob J. for the Wagner number!] On pre-1965 tapered axle drums use the axle part that is in your existing brake drum and install it in the replacement drum."

You may be able to find that puller at an old-time rental establishment too.

Thanks,
Gary H.

 

-----Original Message----- 
>thank Nick.. I'll save this, I know I'll need it... 
>I think I'm going to see if there is a puller that works. I did a search 
>and there seems to be dozens of puller designs from $60 to over $200.. 
>trying to find the right one for a Chrysler going to be a trick
>
>Nick Tiberio wrote:
>> 
>> I've had very good results with Craig Stanley, Mobile Parts, in West 
>> Hempstead, NY. Tel. 516 485-1935. In the past I've ordered brake drums, 
>> wheel cylinders, brake shoes, full brake kits, bushings etc. for both of 
>> 
>> my 63' Plymouths.
>> 
>> Nick Tiberio
>> FuryUs63


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER