Hood scoop progress

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

Ollie has been giving me tips so I guess if anything goes wrong it's his 
fault :-) I did my welding on the 18ga withh my 90amp Harbor Freight 
flux wire welder set as low and slow as it would go. I didn't blow too 
many holes. I put some JB Weld on the inside of the scoop along the rear 
seams and that sealed things up. Now i have some Evercoat fiber glass 
filler and then some liteweight filler to purty it up with. I think it's 
coming along OK. I'll be starting on smoothing out the nose of the hood 
next and then I can cut the hole in the hood to mount the scoop. Heck I 
may even get it done in my lifetime :-)

I am having fun!


Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
http://1962to1965mopar.ornocar.org/ml-kinsley64polara.html


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.