Steve, I may have a short or long '65 cable if you do keep the car. Happy motoring. Gary P.----- Original Message ----- From: "MO ( Steve Mick)" <micher@xxxxxxxxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx> Sent: Wednesday, February 02, 2011 11:52 AM Subject: Re: Fury update
Hay Dave B, Thanks for sending me some of your snow, but I really didn't want the wind! What do I expect for free??The Dodge did not have an engine or tranny , but it had been a colume shift 3 speed. I would guess a 318 engine as I did not have to change the K frame to put in a big block. The Sport Fury has a later 60's 383 engine and tranny. With the car, I got a dis-assembled 383 that I was told had a correct casting number block Also two other 727 tranny and another for parts. That is why my poor little Chebby 1/2 ton 305 C.I. pickup is squatting so much in the pics! I also got the stock console and bucket seats. If I keep the car, I will need a cable shift 727. ................MO{Steve Mick} http://stevemick1964dodge.shutterfly.com/----- Original Message ----- From: "David Bailey" <bb64d440@xxxxxxxxxxx>To: <1962to1965mopars@xxxxxxxxxx> Sent: Tuesday, February 01, 2011 7:01 AM Subject: RE: Fury updateSteve, congratulations on your accruement! Must be nice to have both the Dodge and Plymouth in 1964 vintage. And both as two door hard tops! Are they both 383 motors?Have fun and good luck with them! Dave Bailey '64 Dodge B-body 440, 2dr ht, 383 cid, 4 bbl 4 spd, '64 Sure-Grip rear axle, duel exh ZZW - Anniversary Gold w/ white side sweep In restoration to - as stock original (So far)To: 1962to1965mopars@xxxxxxxxxx From: micher@xxxxxxxxxxxxxxx Subject: Fury update Date: Tue, 1 Feb 2011 01:01:32 -0600Tonight we got some pics up on shutterfly--joining the Dudge Click on the link below my name below. It needs to be re-arranged as it starts off withthe Dodge 1st pic.I made room in the shop and got the Fury inside last week. Problem: It wouldnot start but would fire when you let off the key, and sometimes when it fired it would start up. And then it ran fine. I don't care for theelectronic Mopar ignition( to many things that can go wrong. So I eliminated the orange box and put in a single points rebuilt distributo and got rid ofa bunch of wires.Left the new looking MSD coil. Still wouldn't start. Checked the ballast resistor and it had bright test light on both endsWTF???? Then I learned that a ballast resistor doesn't drop voltage untilit warms up. Wouldn't start. Then I found out that the hot wire to theballast was not hot when the engine was cranking. AH- HAA! Ran a jumper from the battery to the input side of the ballast, and BANG--it started right up. Ran pretty rough, but after a while the engine quit and would not fire.?? I had another good coil that did not need a ballast resistor and ran a jumper wire from the battery to the input sideof the coil.. That fixed the quitting problem, but it still ran rough. Checked over the REBUILT distributor andfound that the points were barely opening. Set the gap at .16 and now itstarts up right away and runs smooth Well smooth as the lumpy cam will letit!Today I got a real surprise. Got it up in the air on jackstands to check outthe underside. Despite the rust you see in the pics, there is no rust inthe floors or inner rocker panels. I knew the frontend had been re-built, but I thought he told me they mads the headers, Nope, the headers are good with no clearancing dents in them and fit real well. May have an issue withremoving the full size starter It has a driveshaft loop and adjustable pinion snubber. Something is a little funkey with the rear axle housing-springs, That will need to be looked into. but it does have the big finnedbrakes on the back. I still have some things to do while it is up in theair, than when weather permits, I will move Ms. Fury to another dry building and get back to Brutus( 64 Dodge.) I will have an update on it in a cupplaweeksList member Fred Pfaulp in AZ. fixed me up with most all of the Sport Furyemblems .etc. that I didn't have---Thanks Fred! Later.................MO {Steve Mick} http://stevemick1964dodge.shutterfly.com/ ----Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!1962 to 1965 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.-- [Non-text portions of this message have been removed] ----Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!1962 to 1965 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.----Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!1962 to 1965 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html and
---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.