RE: '64 Chrysler Questions

["Gary H." <spigot2039@xxxxxxxxxxx>]

There are not too many sources for C body headers. The two vendors mentioned make quality pieces and are trouble free. Lesser units that leak and wear out are more costly in the long run in my 2c. 

The other alternative is to find some of the hi-po cast iron exhaust manifolds made for the late 60's early 70's Mopar hi-performance factory motors and use them in place of the "log" style used in 1964.

Thanks,
Gary H. 

-----Original Message----- 
 
>Someone else happened to mention TTI, but apparently headers from this company cost an arm and a leg and your left testicle. I will look into Schumacher, especially since you are the second person who has mentioned this company. 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.