W wiper pivots

["MO ( Steve Mick)" <micher@xxxxxxxxxxxxxxx>]

My pivots ( bellcrank that goes thru the cowl ) shaft is binding in its 
housing.   1964 Dodge B body. I see there are kits to re-seal it and install 
grease zerks.  I can not see how to remove the shaft to clean it and lube 
it.  The kit shows a thick rubber bushing that I can't figger where it goes. 
Can someone please tell me how to dis-assemble the shaft from the housing , 
and how the kits install? That and take apart  the pedal asssembly is my 
project for the day...Thanks for any help.............................MO

{Steve Mick}
http://stevemick.shutterfly.com/pictures#Part%202 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.