Re: 64 Belvedere 50/50 Front Seat Upholstery, Need Help
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: 64 Belvedere 50/50 Front Seat Upholstery, Need Help




Dont know if this helps, but I do know that the original seat material was sold 19 inchs wide. The vinyl was sold much wider. I know this from doing a few interiors from scratch and I still have a partial roll of original 65 Bel 1 seat cloth. I just measured it to be sure, and it is 19 inchs.

Hope this helps
Donnie
----- Original Message ----- From: "Don Owen" <d4owe9@xxxxxxxxxxx>
To: "Mopar Discussion Group" <1962to1965mopars@xxxxxxxxxx>
Sent: Wednesday, October 06, 2010 8:54 AM
Subject: 64 Belvedere 50/50 Front Seat Upholstery, Need Help





Dear Group:
I need some measurements for the correct upholstery on the 50/50 front seats with Belvedere trim, 1964 2 door sedan.
If anyone has a such a 50/50 seat I would appreciate a little help.
We need measurements for the cloth inserts on each seat (should be the same for both). In other words, how far is the piping (which covers the cloth perimeter where it meets the vinyl) from the seat side and front edges.
Also need  the seat backs measurements. Hope this makes sense!
Some photos along with the measurements would probably help if anyone has the time.
Thanks! Donny, 64 Belvedere
--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.




----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.