Re: ECU and Engine Miss Diagnosis

[Joey <jake4@xxxxxxxxxx>]

check the air gap in the distributor also, takes a brass feeler gauge, if 
you find bad wires I would suggest fire core 50's for it

Joey
----- Original Message ----- 
From: "Donald Gallimore" <dongallimore@xxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Sunday, October 03, 2010 5:42 PM
Subject: ECU and Engine Miss Diagnosis


> Last trip to the drag strip, I developed a miss around 2500 RPM and up. 
> Engine
> seemed like it was loading up but carb looked good - floats levels are 
> right
> and we changed nothing on the carb. This may have been developing for 
> weeks and
> finally showed up late in eliminations.
>
> I'm going to replace the cap, rotor, reluctor and pick up in the 
> distributor
> since they are relatively small cost items. Question is there a way to 
> test the
> ECU?
>
>
> Lastly, any ideas on what (else) to check to eliminate the miss?
>
> Akron Don Gallimore 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.