Re: sending unit

["Gary H." <spigot2039@xxxxxxxxxxx>]

I've seen people solder a wire from the outlet of the sending unit, where the factory grounding unit is supposed to clamp, and run the other end of the wire to the unibody and secure it.  


Thanks,
Gary H.

-----Original Message-----
>
>I had to do something similar to mine, the factory ground strap to the
>fuel line was rusted and I could not get a ground through the locking
>ring so I tinned (soldered) a 18ga wire and stuck it under the locking
>ring as it tightened. Works like a charm, but I'd like to come up with
>something more permanent...
>
>- Dave


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.