Does anyone out there sell an adapter plate that would allow me to put a Holley 2 barrel carb on my stock Poly 2 barrel intake manifold? Thanks, Scott --- On Sat, 7/24/10, Dennis J. <djohn14296@xxxxxxxxx> wrote: > From: Dennis J. <djohn14296@xxxxxxxxx> > Subject: Re: Poly Stroker project > To: 1962to1965mopars@xxxxxxxxxx > Date: Saturday, July 24, 2010, 5:52 PM > Nice Nick, very nice....Tks for > sharing > DJ > > > --- On Sat, 7/24/10, Nick Tiberio <furyus63@xxxxxxxxxxx> > wrote: > > > From: Nick Tiberio <furyus63@xxxxxxxxxxx> > > Subject: Poly Stroker project > > To: 1962to1965mopars@xxxxxxxxxx > > Date: Saturday, July 24, 2010, 11:06 AM > > > > 1963 Plymouth Fury making progress since the early > spring. > > Engine and > > front end out, painted engine compartment, poly > stroker > > engine/trans, > > suspension are in and this past week finished up on > the > > cooling system. > > Trunk mounted battery and wire harness are next. > > > > A few photos here of the progress. > > > > http://s329.photobucket.com/albums/l380/FuryUs63/Poly%20Stroker/?start=all > > > > > > Nick Tiberio > > furyus63 > > > > > > ---- > > Please address private mail -- mail of interest to > only one > > person -- directly to that person. I.e., send > > parts/car transactions and negotiations as well as > other > > personal messages only to the intended recipient, not > to the > > Clubhouse public address. This practice will protect > your > > privacy, reduce the total volume of mail and fine tune > the > > content signal to Mopar topic. Thanks! > > > > 1962 to 1965 Mopar Clubhouse Discussion Guidelines: > > http://www.1962to1965mopar.ornocar.org/mletiq.html and > > http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. > > > > > > >