Re: Victor Heads and Distributor Clearance

["Gary H." <spigot2039@xxxxxxxxxxx>]

Maybe contact tech support at MSD. They have to have run into this before I assume. 
http://www.msdignition.com/

Thanks,
Gary H. 


-----Original Message-----
 
>Anyone out there running the Edelbrock/Procomp Victor heads on a RB? If so 
>what distributor are you using? The procomp distributor I have on is hitting 
>the corner of the head with cap clips and the MSD distributor I want to use 
>is even wider than the Procomp. There is enough meat on the corner of the 
>head to grind some metal off but I really don't want to do that unless it is 
>the only option left. Any suggestions would be greatly appreciated.
>Nico Over
>Va. Beach, Va.
>1963 Dodge 330
>1964 Plymouth SF 451
>195 Plymouth Bel II convert 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.