There is an inner fenderwell panel you can remove. Held on by 4 or so hex head srews with large washers plus the one bolt on the fender. A lot of work and breaks the undercoating if your worried about originality. Try the contorsionist stuff from the door hinge area. If that doesn't work, then take out the panel. Akron Don Gallimore ----- Original Message ---- > From: Douglas Sutherland <pluckedchickens@xxxxxxxxxxx> > To: 1962to1965mopars@xxxxxxxxxx > Sent: Sat, June 19, 2010 7:40:55 AM > Subject: Removing '64 Fury side trim from front fender > > Tight space! The two speed nuts (closest to leading edge > of front door) are quite difficult to get to, let alone turn. Any > special tools or technique required to remove these? Thanks,Doug > > > _________________________________________________________________ The New > Busy is not the too busy. Combine all your e-mail accounts with > Hotmail. http://www.windowslive.com/campaign/thenewbusy?tile=multiaccount&ocid=PID28326::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_4 -- [Non-text > portions of this message have been removed] ---- Please address > private mail -- mail of interest to only one person -- directly to that > person. I.e., send parts/car transactions and negotiations as well as > other personal messages only to the intended recipient, not to the Clubhouse > public address. This practice will protect your privacy, reduce the total volume > of mail and fine tune the content signal to Mopar topic. > Thanks! 1962 to 1965 Mopar Clubhouse Discussion > Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and > http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. > --^---------------------------------------------------------------- This > email was sent to: > href="mailto:dongallimore@xxxxxxx">dongallimore@xxxxxxx EASY > UNSUBSCRIBE click here: http://topica.com/u/?bUrDWg.caU2BH.ZG9uZ2Fs Or send > an email to: > href="mailto:1962to1965mopars-unsubscribe@xxxxxxxxxx">1962to1965mopars-unsubscribe@xxxxxxxxxx For > Topica's complete suite of email marketing solutions > visit: ?p=TEXFOOTER --^----------------------------------------------------------------