Re: crank test?

[Gary Mopar 413 <mopar413@xxxxxxxxxxx>]

Stand the thing on end and then tap it with   small hammer or like tool.  If it rings then most likely it it ok.   If you get a dull thud then it is bad.  Probalby cracked.  Other than takeing it to a maschine shop that is only way I can tell.   Need to mic it to see if it is turnable or needs to be turned.
> Hi all,
> 
> Is there an easy way to check a crankshaft to see if it is okay? I have a crankshaft in a 318 parts engine I want to ship to a fellow but I don't want to send him a dud. Beside the obvious, like snapped, any tips? 
> 
> Thanks,
> Gary H. 
> 
> 
> ----
> Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
> 
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 
> 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.