Trunk Mat
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Trunk Mat



I'd like to get feedback on other experiences when buying replacement
trunk mats.

I ordered a molded one from StockInteriors.com for my Coronet and it
arrived yesterday. It actually fits nicely everywhere but the back.
It's ~3" too short along the tailpanel edge and the notches for the 2
small angled rear braces are cut too far inboard....basically the
outside edge of the notch is where the inside edge should be. Is this
about as good as it gets with these pre-cut pieces or should I fuss?
Is my only way to get one that's "right" to buy a sheet of material
and cut it myself?

Thanks

-- 
Bill M
65 Coronet 500 'vert http://1962to1965mopar.ornocar.com/mmo62008.html
73 Dart Sport, 00 Cherokee Sport, 01 Dakota SLT
21 Model T Depot Hack, 92 Accord, 06 Mazda 3


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.