Distributors - (was Re: Torque Converter / Trans Input Shaft Size)

["Gary H." <spigot2039@xxxxxxxxxxx>]

Here is an article about Mopar distributors:

http://www.moparmusclemagazine.com/techarticles/engine/mopp_0809_distributor_setup_quick_tech/index.html

Thanks,
Gary H.


-----Original Message-----
 
 
>What should I be looking for as far as numbers go? And to ask the
>stupid question...how do I do this? I usually set it to ~ factory then
>tweak it as advanced as I can without pinging. And aren't Mopar
>distributors fairly easy to change the advance curve in by springs or
>weights or something? I'm good w/ general mechanical stuff but just
>don't have any experience tuning carbs or ignitions at all.
>
>-- 
>Bill M 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.