Just so you know I'm still here

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

OK, I'll post something. Did I mention that while I was under the car 
changing the fuel pick-up I spotted a leaking front seal on the diff and 
the boot on my ball & trunion is torn again. It was brand new. (A couple 
years ago) I'm trying to figure out a good way to put in a driveshaft 
safety loop but let me tell you my exhaust has it so encapsulated that I 
don't know where I could put one. I doubt if the rear trans type would 
fit. Actually I don't think the driveshaft could go anywhere. I just 
hope I can get it out for the repairs!

OK, somebody else's turn :-)

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.