>From Mopar Muscle: Max Wedge heads are easily identifiable by the lack of a heat cross-over passage, large 1.88-inch exhaust valves, and very large ports. Casting numbers for the Max Wedge heads end in either 286, 209, or 518 Akron Don There are no heat riser ports on a max wedge head. The area between the two center intake parts should have no openings. Then there's the casting number which is located in the valve springs area. I'm sure there's a listing of head casting numbers somewhere on the 62-65 website. Akron Don ________________________________ From: Harry Skalla <moweepea@xxxxxxxxxxx> To: 1962 1965 <1962to1965mopars@xxxxxxxxxx> Sent: Thu, December 24, 2009 10:50:27 AM Subject: heads First of all Merry Christmas to all. I have a set of 426 heads on my car, how do I tell if they are Max Wedge heads or street wedge heads? Without taking them off.Thanks...Butch ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: -- [Non-text portions of this message have been removed] ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. ________________________________ From: Donald Gallimore <dongallimore@xxxxxxx> To: 1962to1965mopars@xxxxxxxxxx Sent: Thu, December 24, 2009 11:39:30 AM Subject: Re: heads -- [Non-text portions of this message have been removed] ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx u/?bUrDWg.bSONJP.YXJjLjYy ?p=TEXFOOTER