RE: Cylinder pressure
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Cylinder pressure



I know this isn't the same engine but my poly in 80K stock form ran 
155psi in 6 cylinders. The other two were like 151 and 152ish. After my 
rebuild they are all 185psi.
Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
=====================================================================
spigot2039@xxxxxxxxxxx wrote:
> 
> The readings should be within 10 to maybe 15psi of each other. Do a dry 
> then a wet test.
> 
> Thanks,
> Gary H. 
>  
> 
> -----Original Message-----
> >From: Dave Isle  
> >Well folk new question what should the compression be on a 361? All I 
> >can remember is that there should be no more then 10% difference between 
> >the cylinders  
>  



Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.