Re: 63 SF Heater Question

[ed keaton <gtx69@xxxxxxx>]

www.napa.com<http://www.napa.com/> Napa auto parts sells a rebuild kit for that for $10.00 and a lot of other mopars.All it is is a rubber seal.I ended up replacing the one on my 69 gtx also.Go to the website and check it out.I shop a lot at napa they can get a lot of the parts other places can't.
  ----- Original Message ----- 
  From: Gary H.<mailto:spigot2039@xxxxxxxxxxx> 
  To: 1962to1965mopars@xxxxxxxxxx<mailto:1962to1965mopars@xxxxxxxxxx> 
  Sent: Sunday, December 06, 2009 9:55 AM
  Subject: Re: 63 SF Heater Question



  Last time I looked no '63 reproduction heater control valves were made. But JC Auto will rebuild your car's heater control valve. 
  http://www.jcauto.com/heater.html<http://www.jcauto.com/heater.html>

  I don't think you need to pull the dash. There are some c shaped clips holding the sections of the heater cover together, if I remember correctly. You can phone Jeff Carter at JC Auto and he will give you some tips on removing the heater control valve I bet. He is a good Mopar guy.

  If the heater core is bad, you'll need to get that rebuilt too, I think, because the last time I looked no reproductions were made. There is a rebuilder listed on the 62-65 Mopar Vendor's Page.

  Let us know how it goes. Take some pictures to share. :)

  Thanks,
  Gary H. 


  -----Original Message-----
   
  >It is starting to get cold, I don't need the heater but I really need to 
  >get the defroster going.
  >
  >I have never had the heater connected in the car, I have a couple of 
  >questions:
  >
  >How do I replace the heater control valve if I need to?  I looked in the 
  >manual and most of the section on the heater discussed the A/C that I 
  >don't have.  All I see is the heater valve in a 90 degree pipe going 
  >into the heater box through a cover with a couple of screws.  
  >
  >Second question, are the heater control valves still available?
  >
  >Last question, will the heater box come out without removing the dash?  
  >I have no idea what the condition of the heater core is and would like 
  >to check it and inspect the heater box if I can get it out.  Again the 
  >manual was not much help.
  >
  >Thanks
  >Dennis 


  ----
  Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

  '62 to '65 Mopar Clubhouse Discussion Guidelines:
  http://www.1962to1965mopar.ornocar.org/mletiq.html<http://www.1962to1965mopar.ornocar.org/mletiq.html>. 


[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.