Cam Question

[Nico Over <nover@xxxxxxxx>]

Hi and Happy Thanksgiving to all. My 63 Dodge MW Clone (440 block) has never
run correctly, always started well but it seemed the engine wasn't all there
even though it was firing on 8. Tore into it this week for a cam change and
found that the timing marks were 180 out on the cam gear, the marks were
aligned with the dot at top position of both the crank and cam gears at TDC. I
would have thought that with the marks aligned as such the car wouldn't even
run. Anyone ever experience this and were your symptoms the same. Any thoughts
would be appreciated. Thanks
Nico Over
Va. Beach, Va 
PS I did not build this motor, it came in the car!


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.