RE: Holley carb ID

[Steven Charette <stevec@xxxxxxxxxxxxxxxxxxxx>]

Rich,
	IIRC the 3310 was a square bore vacuum secondary carb that they used
to refer to as a 780cfm.  I've seen it recently as a 750, but I don't recall
them having a rear accellerator pump.

SC 

-----Original Message-----
From: Rich Kinsley [mailto:rlkinsley@xxxxxxxxx] 
Sent: Monday, November 23, 2009 6:10 PM
To: 1962to1965mopars@xxxxxxxxxx
Subject: Holley carb ID




Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

I have a Holley carb that I'd like to ID. I was told it's a 750cfm. It's a
4bbl double pumper with 3310-6  and 2959  stamped on the choke air horn.
There's a P-80 cast on the main body side. Under the air filter gasket area
there's a 6R 6931  and the sec nozzles are ^SR-107. Can anybody ID it
correct?


----
Please address private mail -- mail of interest to only one person --
directly to that person.  I.e., send parts/car transactions and negotiations
as well as other personal messages only to the intended recipient, not to
the Clubhouse public address. This practice will protect your privacy,
reduce the total volume of mail and fine tune the content signal to Mopar
topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.