Re: Longer Throttle Cable Needed

[Dodger7998@xxxxxxx]

On my maxwedge I went to a cable off of a leaning tower of  
power,,,,,,,,,,,,any chance  you could use a spacer under the cable holder  as well
 
 
In a message dated 9/7/2009 12:04:02 A.M. Central Daylight Time,  
dennis.2914@xxxxxxxxx writes:


I  want to use a 1" fiber 4-hole carb spacer on my 383 with a Holley  
carb.  My throttle cable is not long enough to work with the  spacer.

I can make a temporary adapter to extend the cable but the  angle will 
not be good and it will not look vary good.

Any  suggestions for new throttle cable and engine cable  bracket?

Thanks
Dennis C.

1996 Dodge Ram 3500 Van  Conversion
1964 Plymouth Belvedere 318 Auto
1963 Plymouth Sport Fury 383  4-speed
1949 Dodge Pickup 289/C4 soon to be changed
1998 Honda Valkyrie  Standard


----
Please address private mail -- mail of interest to  only one person -- 
directly to that person.  I.e., send parts/car  transactions and negotiations as 
well as other personal messages only to the  intended recipient, not to the 
Clubhouse public address. This practice will  protect your privacy, reduce 
the total volume of mail and fine tune the  content signal to Mopar topic.  
Thanks!

'62 to '65 Mopar Clubhouse  Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.  




[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.