I knew 3M probably made weather strip adhesive.. love 3M ;) I was thinking it would look better if the ends meet at the back of the trunk, rather than meeting at the latch, but will I have leaking? Dodger7998@xxxxxxx wrote: > > > I used the black 3M weather strip adhesive, it worked great,,,,,,,I > split > mine at the latch,,,,,,,,think it might have looked better if I had done > it > at the middle of passenger area, worked best with two people, one to > hold > the strip while the other put on glue about 2 foot at a time, and stuck > in > place,,,,, > > > In a message dated 9/4/2009 9:51:51 P.M. Central Daylight Time, > 62pluckedchicken@xxxxxxxxx writes: > > > Got the trunk painted.. just about ready to install new > weather-stripping... 2 questions > > 1) any suggestions on a good glue/cement? > 2) where is the best start/end point? have the weather-stripping ends > meet at the latch? the back (closest to the passenger compartment)? or > on side? > > > ---- > Please address private mail -- mail of interest to only one person -- > directly to that person. I.e., send parts/car transactions and > negotiations as > well as other personal messages only to the intended recipient, not to > the > Clubhouse public address. This practice will protect your privacy, > reduce > the total volume of mail and fine tune the content signal to Mopar > topic. > Thanks! > > '62 to '65 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html. > > > > > [Non-text portions of this message have been removed] > ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.