Re: Trunk weather-stripping
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Trunk weather-stripping



napa  carries a good weather stripping adesive  start  by lying it down with the ends at the latch  make sure it fits with little to no gap then put adesive at the top and work too the latch   get 2 tupes as you  do not too run out  with 10 inches left     do it out of the direct  sun lite ,,,good luck 

--- On Fri, 9/4/09, 62pluckedchicken@xxxxxxxxx <62pluckedchicken@xxxxxxxxx> wrote:

> From: 62pluckedchicken@xxxxxxxxx <62pluckedchicken@xxxxxxxxx>
> Subject: Trunk weather-stripping
> To: 1962to1965mopars@xxxxxxxxxx
> Date: Friday, September 4, 2009, 10:51 PM
> 
> Got the trunk painted.. just about ready to install new 
> weather-stripping... 2 questions
> 
> 1) any suggestions on a good glue/cement?
> 2) where is the best start/end point? have the
> weather-stripping ends 
> meet at the latch? the back (closest to the passenger
> compartment)? or 
> on side?
> 
> 
> ----
> Please address private mail -- mail of interest to only one
> person -- directly to that person.  I.e., send
> parts/car transactions and negotiations as well as other
> personal messages only to the intended recipient, not to the
> Clubhouse public address. This practice will protect your
> privacy, reduce the total volume of mail and fine tune the
> content signal to Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
> 
> 





Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.