I just got a chaeap one from the parts store Gary, I think I paid less than $35 for it. It's really just a ridge reamer, I guess. Kinda like the old 3 finger wheel cylinder hone, but larger. spigot2039@xxxxxxxxxxx wrote: > > Thanks, I don't have a fine cylinder hone though. Any other shadetree > method to do this? > > Gary H. > > -----Original Message----- > >From: Jeff Adams > > >You might also try a fine cylinder hone after protecting the piston > >tops. > > > >spigot2039 wrote: > >> > ... I noticed a small area of rust in the top > >> of the cylinder that was not visible from the 12 o'clock view. > Jeff Adams 64 Polara ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.