I might have one from a 65 Coronet with poly & 727 I parted out. I'll have to look.
Don in VA Brian Safford wrote:
My transmission mount is one of those that has a spring in it ... the guy I spoke with at Schumacher Creative Services said if I could find a crossmember from a 63, 64 or 65 automatic, I could switch over to the type they sell and it would be a lot easier to do what I'm trying to do. Anyone have a 63, 64 or 65 crossmember from an automatic they'd like to part with? Thanks, Brian On Thu, Jun 11, 2009 at 12:53 PM, Brian Safford<hzf9vv@xxxxxxxxx> wrote:I've managed to move my poly 318 1/2 inch towards the rear so my TTI headers will fit better, and I've modified my original trans mount holes by 1/2 inch as well. Problem is that now the trans mount interferes with the parking sprag housing. I can further modify the trans mount by removing material so as to remove the interference but am wondering if there might be a better solution. Thoughts? Thanks in advance, Brian -- Sent from my mobile device---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html.
---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html.