Re: transmission mount
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: transmission mount



Today was a great day.

Managed to modify my own d*mn transmiaaion mount ( a rotozip is a fine
piece of machinery ) and I just finished connecting the driveshaft.

My drivetrain is now 1/2 inch closer to the rear axle - now I hope
like h*ll the headers will fit better.

Brian

On 6/11/09, Brian Safford <hzf9vv@xxxxxxxxx> wrote:
> I've managed to move my poly 318 1/2 inch towards the rear so my TTI
> headers will fit better, and I've modified my original trans mount
> holes by 1/2 inch as well.
>
> Problem is that now the trans mount interferes with the parking sprag
> housing.
>
> I can further modify the trans mount by removing material so as to
> remove the interference but am wondering if there might be a better
> solution.
>
> Thoughts?
>
> Thanks in advance,
> Brian
>
> --
> Sent from my mobile device
>

-- 
Sent from my mobile device


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.