Re: Headliner Install

[Jim Altemose <jaltemoose@xxxxxxxxx>]

${top_text_ad}
Where's the best place to get a headliner for a 63 Polara 500?

Thanks.

- Jim
Jim Altemose, Long Island, NY
'63 Polara 500 (Max Wedge)
'63 Polara 500 (383)
'65 Belvedere I (Street Wedge)
'71 Bronco


On Thu, May 21, 2009 at 7:29 AM, Joey <jake4@xxxxxxxxxx> wrote:
>
> I should clarify, the front and rear glass were out of my car because it had
> been recently painted, normally the glass shouldn't have to be removed, it
> did make it a lot easier for this old guy though!
>
> Joey
> ----- Original Message ----- From: "Cindy and Jeff" <cin.bad@xxxxxxxxxxxx>
> To: <1962to1965mopars@xxxxxxxxxx>
> Sent: Wednesday, May 20, 2009 9:09 PM
> Subject: Re: Headliner Install
>
>
>>
>> I've been working on car interiors for 28 years.  I've done several 62-65
>> B
>> Body headliners (2 for myself) and I've never done one with the back and
>> front window out.  2 have been with a full cage.  The trick is to lay it
>> in
>> the sun before you install it to let the sun take the big wrinkles out and
>> do it in the heat of the day. Remember that you will need to pull tight
>> working side to side front to back.  I've pulled it half-ass tight then
>> went
>> back in an hour and pulled it tighter.  Take your time.
>>
>> Cindy
>>
>>
>> ----- Original Message ----- From: "Joey" <jake4@xxxxxxxxxx>
>> To: <1962to1965mopars@xxxxxxxxxx>
>> Sent: Wednesday, May 20, 2009 3:57 PM
>> Subject: Re: Headliner Install
>>
>>
>>>
>>> Hi Mike,
>>> I am not an expert by any stretch of the imagination but I did my 65 with
>>> the front and rear glass out and it seemed easier to me but the this is
>>
>> only
>>>
>>> the first one I have ever done. The sides were more interesting to me
>>> because after watching a couple of later 60's cars getting done I thought
>>
>> I
>>>
>>> had to stretch mine over the outer edge like those guys did but early
>>> cars
>>> do not get stetched over the outside edge, they get tucked straight up
>>> the
>>> side on the inside. I would make sure when you remove the old liner that
>>
>> the
>>>
>>> teeth on the side hangers are nice and straight, if not you will have a
>>
>> hard
>>>
>>> time getting it to latch on tight. Man, I sure hope I explained this
>>
>> right!
>>>
>>> Joey
>>> ----- Original Message ----- From: <mikelj@xxxxxxx>
>>> To: <1962to1965mopars@xxxxxxxxxx>
>>> Sent: Wednesday, May 20, 2009 1:57 PM
>>> Subject: Headliner Install
>>>
>>>
>>> >
>>> >
>>> >
>>> > I now have some time to take my '64 Dodge Polara 500 to get the new
>>> > headliner and insulation installed, but the upholstry shops I have
>>> > contacted keep asking me if they will have to remove the front
>>
>> windshield
>>>
>>> > and rear glass to install it.  I was under the impression that the >
>>> > thick
>>> > chrome strips with numerous screws around the interior roof line and
>>> > headliner could be removed to remove the headliner and replace without
>>> > removing any glass.  Am I right?  Thanks.
>>> > Mike
>>> >
>>> >
>>> >
>>> >
>>> > --
>>> > [Non-text portions of this message have been removed]
>>> >
>>> >
>>> > ----
>>> > Please address private mail -- mail of interest to only one person -- >
>>> > directly to that person.  I.e., send parts/car transactions and
>>> > negotiations as well as other personal messages only to the intended
>>> > recipient, not to the Clubhouse public address. This practice will
>>
>> protect
>>>
>>> > your privacy, reduce the total volume of mail and fine tune the content
>>> > signal to Mopar topic.  Thanks!
>>> >
>>> > '62 to '65 Mopar Clubhouse Discussion Guidelines:
>>> > http://www.1962to1965mopar.ornocar.org/mletiq.html.
>>> >
>>> >
>>>
>>>
>>> ----
>>> Please address private mail -- mail of interest to only one person --
>>
>> directly to that person.  I.e., send parts/car transactions and
>> negotiations
>> as well as other personal messages only to the intended recipient, not to
>> the Clubhouse public address. This practice will protect your privacy,
>> reduce the total volume of mail and fine tune the content signal to Mopar
>> topic.  Thanks!
>>>
>>> '62 to '65 Mopar Clubhouse Discussion Guidelines:
>>> http://www.1962to1965mopar.ornocar.org/mletiq.html.
>>>
>>>
>>>
>>>
>>
>>
>> ----
>> Please address private mail -- mail of interest to only one person --
>>  directly to that person.  I.e., send parts/car transactions and
>> negotiations as well as other personal messages only to the intended
>> recipient, not to the Clubhouse public address. This practice will protect
>> your privacy, reduce the total volume of mail and fine tune the content
>> signal to Mopar topic.  Thanks!
>>
>> '62 to '65 Mopar Clubhouse Discussion Guidelines:
>> http://www.1962to1965mopar.ornocar.org/mletiq.html.
>>
>>
>
>
> ----
> Please address private mail -- mail of interest to only one person --
> directly to that person.  I.e., send parts/car transactions and negotiations
> as well as other personal messages only to the intended recipient, not to
> the Clubhouse public address. This practice will protect your privacy,
> reduce the total volume of mail and fine tune the content signal to Mopar
> topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html.
>
>
>
>

${bottom_text_ad}
----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.

This email was sent to: ${recipient}

u/?bUrDWg.${encoded_sub_id}.${EMC}