oil pan, torque converter

[C Singleton <csingleton@xxxxxxxxxxx>]

i have fabricated a new oil pan for my 65 belv from the dimensions listed in the tech ramblins section on oil pans.  my question is the engine is a 383HP and it has a windage tray.  the new pan has about a 1/8 inch clearance between it and the windage tray.  is this going to be a problem?  also how much clearance should i have between the bottom of the pan and the pickup?
next question is torque converter recommendations.  i am looking at a 10 inch converter with 2600-2800 stall.  would i be happy with this for a street car?
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.