OK...that makes sense now!! Does anyone know where I can get the styrofoam bearing flange to backing plate seals? or where I can buy thin material to make them? I'm sure they are somehow figured into the endplay adjustment somehow. -- Bill M 65 Coronet 500 'vert http://1962to1965mopar.ornocar.com/mmo62008.html On Tue, Apr 28, 2009 at 7:33 PM, Stevan Miner <miner@xxxxxxxxxxx> wrote: > > Those would be the inner seal. The outer seal is the thin seal that is in > the bolt flange. > Stevan Miner > Miner Auto Service > Winnebago, MN > > -------------------------------------------------- > From: "Bill" <Y1TopBanana73@xxxxxxxxx> > Sent: Tuesday, April 28, 2009 12:15 PM > To: "62-65 Mopar List" <1962to1965mopars@xxxxxxxxxx> > Subject: 8.75 Axle Seals > >> Are the axle seals that are inboard of the wheel bearings considered >> the outer or inner seal? I can never remember this. >> >> -- >> Bill M >> 65 Coronet 500 'vert >> http://1962to1965mopar.ornocar.com/mmo62008.html ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.