Dont take it as gospel it is from a poly. That is what i seem to remember but I am almost over the hill. I basiscally just hunted til i found what I was looking for.
Don----- Original Message ----- From: "Schuyler Wrobel" <sky62@xxxxxxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx> Sent: Tuesday, April 28, 2009 9:06 PM Subject: Re: Went to the shop and measured my pulley. 6 1/4 inch
could it be that only the Canadian Poly head motors got the 6 1/4 inch pulleys? cuz the two water pump pullys I have both measure 6 1/2" for the Poly 318.??? how standard are water pump pulleys? could one off any older car do? Schuyler 62 Dodge Dart 440 wagon w/ Poly 318 <http://www.1962to1965mopar.ornocar.org/ml-wrobel62.html>FYI - I Do the Decal designs for the Poly head 318 and more! email me with your needs -<sky62@xxxxxxxxxxxxx> On Apr 28, 2009, at 10:56 AM, Don Dulmage wrote:6 1/4 inch Measured it three times to be sure don [Non-text portions of this message have been removed]----Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!'62 to '65 Mopar Clubhouse Discussion Guidelines:
---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html.