RE: Daytona Cams cam for poly 318

[Jeff Adams <ledman_70@xxxxxxxxxxx>]

I'll be there, as always. Is anybody interesed it meeting at the 
cruise-in in Heath on Friday nite of the Nats? We usually cruise the 
Polara a few times then park at Best Buy to watch the action.

Brian Safford wrote:
> 
> Way  back when, Gary P wrote that article about the "Rodney
> Dangerfield" Poly 318 and referenced a camshaft from Daytona Cams.
> 
> I bought that cam and have been very happy with it.  Unfortunately, I
> seem to have misplaced the little card that had the cam's
> specifications.
> 
> Does anyone have that information?
> 
> I'm troubleshooting my Barry Grant Road Daemon and the tech folks at
> BG say they need to have my cam specs before they can provide much
> assistance.
> 
> Telling them it goes "whumppity whumpitty whumppity" didn't seem to help 
> :-)
> 
> By the way, I finally finished moving my motor back the 1/2 inch so
> the TTI headers would clear the steering linkage. That ball-n-trunion
> driveshaft might not get much respect elsewhere, but having enough
> slack for the engine/tranny move was wonderful.
> 
> I used that high temp grey silicone stuff that was recommended on the
> lower exhaust bolts ... no leaks whatsoever !!!
> 
> I can't make Carlisle ... but am more than likely going to the Mopar
> Nat's ... anyone else going?
> 
> Regards,
> Brian Safford
> '62 Dart 440 - Poly 318



Jeff Adams
64 Polara


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.