Re: 1959 to 1963 rear axle shaft
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: 1959 to 1963 rear axle shaft




Bearing adjustment is achieved by the use of shims on the alxe housing flange.

  Jimmy


Christopher Gleffe wrote:
Hey,

has anyone directions how to assamble the two pice rear axle shaft (1959 - 1963). It is not shown in my 64 service manual.

Especially how do I adjust the bearings and where to put the outer rotary shaft ring.

It would be great if someone could send a copy via. E-mail.

Thank You so far,

Chris


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.