Re: Kick down linkage

[Bill <Y1TopBanana73@xxxxxxxxx>]

Yup...no linkage. The whole purpose of the linkage it to tell the
trans what position the throttle is in so it knows when to do it's
thing...shifting up or down. and since YOU are telling the trans when
to shift, it's just dead weight.

Bill M
65 Coronet 500 'vert

On Fri, Dec 12, 2008 at 1:12 PM,  <chymar01@xxxxxxxxxxx> wrote:
>
>
> No kickdown is needed with a manual valve body. You can remove the lever if you want.
>
> Mark
>
>
> ----- Original Message -----
> From: Dodger7998@xxxxxxx
> To: 1962to1965mopars@xxxxxxxxxx
> Sent: Friday, December 12, 2008 1:07:53 PM GMT -05:00 US/Canada Eastern
> Subject: Kick down linkage
>
>
>
> I asked this question some months ago, and did not get a clear answer
> ,,,,,,,,, I have a manual shift reverse pattern trans with a low gear set in
> it,,,,,,,,,,do I need kick down linkage installed on it? or maybe just a spring
> to keep the lever in place?


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.