Hi Mike,I don't know whether it's the same or not but on my 65 Satellite the bottom moulding butts up tight against the wheel lip moulding both front and rear.
Stevan Miner Miner Auto Service Winnebago, MN -------------------------------------------------- From: "Mike Phelps" <mikeph@xxxxxxxxxxxxx> Sent: Sunday, November 30, 2008 7:41 PM To: <1962to1965mopars@xxxxxxxxxx> Subject: Rocker moulding
Can someone measure the distance between the front and back of the rocker moulding and the wheel openings on a 65 Belvedere? I'm putting the trim back on and it seems my body man covered up the holes on the quarter and the fender. I'm assuming it's centered between the wheel openings but I'm not sure. Thanks Mike Phelps 1965 Plymouth Belvedere II Convertible 361/727 2004 Hemi Ram Quad Cab 2004 Chrysler 300M 3.5HO 2004 PT Cruiser 2.4 Turbo ----Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!'62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.
---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html.