I got my engine back from the machine shop at long last. Now to start putting the finishing touches on it. One of my first projects is to solve the problem of it puking oil out of the rear valve cover breather. My new Holley has a PCV port that I suppose I should use. So I'd like it not to be sucking oil into the carb. The M/T valve cover I'm using has threaded stand offs flanking each opening giving me a perfect place to anchor a baffle. So I made a template out of cardboard and will probably use some alum. sheet to fab the baffles. I'm thinking I should make the baffles fit tight to the sides with @ a 1/2" gap at either end. Could I use some RTV or something similar to seal along the edges where it meets the cover? The main reason being so that it doesn't sag and hit the rockers. There would only be about 1/4" clearance. Otherwise I suppose I could probably form a bead into it to make it a little more rigid. I know some of you have done this mod. What did you do? Here's some pictures to illustrate: http://s204.photobucket.com/albums/bb1/63mopar/ Paul L. '63 Sport Fury 440/727 http://www.1962to1965mopar.ornocar.org/ml-lennemann63.html ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.