RE: 413 cam plug
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: 413 cam plug



Thank you, Stevan.  My friend told me the same thing, but I was a little 
nervous because a couple of big blocks I've looked at had them in deeper 
than that.  There is a machined ridge inside the hole--do you think it 
is there to stop it from going in too far, maybe?

Sean


Stevan Miner wrote:
> 
> Hi Sean,
> I install them with a bushing driver kit that I have although a socket 
> that just fits into the cup will work too. I drive the cup in till the 
> outer edge is flush with the block, then I take some silicone sealer and 
> wipe around the edges.
> Stevan Miner
> Miner Auto Service
> Winnebago, MN


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.