RE: Ignition issue - again
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Ignition issue - again



Thanks Dan. It seems to me like it might have been the bulkhead 
connector last time, but I have tried unhooking and cleaning the 
contacts on it already. I'll try the other tips you suggested.

Dan McCormack wrote:
> 
> Jeff it sounds like you're not getting power in the starting circuit 
> somewhere. Assuming you have a single and not a double ballast resistor 
> and 
> it's hooked up correctly I suspect your problem is in the ignition 
> switch or 
> the bulkhead connector. You could try the old standby and have someone 
> crank 
> the engine while holding a spark plug wire near ground and see if you 
> have 
> spark. A safer test would be to disconnect the neutral start switch from 
> the 
> starter relay (so the engine can't crank) and have someone hold the key 
> in 
> the start position while you check and see if you have voltage to the 
> positive side of the coil. (You have the negative side of the coil going 
> to 
> the distributor right?) There's 2 connectors on the ignition switch that 
> are 
> hot in the start position, one that kicks in the starter and the other 
> sends 
> voltage to the coil. If there's no voltage to the coil in the start 
> position 
> then check the ignition switch. If that's ok then check the wire coming 
> out 
> of the bulkhead connector that goes to the coil in the start position.
> 
> Dan
> 
> 
> ----- Original Message ----- 
> From: "Jeff Adams" <ledman_70@xxxxxxxxxxx>
> To: <1962to1965mopars@xxxxxxxxxx>
> Sent: Wednesday, July 16, 2008 8:30 AM
> Subject: Ignition issue - again
> 
> 
> >
> > I know I asked this before, but I'm still fighting this issue.
> > Apparently, when the coil died on my Polara a few weeks ago something
> > else happened as now the car won't start while cranking, but as soon as
> > the key is released it fires. I replaced the resistor, but no go. All
> > connections seem to be good.  I had this same issue last year and it
> > turned out to be something simple, but being the old fart that I am I
> > can't remember what I did to fix it... HELP!!
> > Jeff Adams
> > 64 Polara
> 



Jeff Adams
64 Polara


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.