Re: seat belt bolts

[Jimmy Peavy <peaver63@xxxxxxxxxxxxxx>]

7/16" NF x 1" thread.The factory used a bolt that was 1 1/2" long. 1/2" 
was unthreaded between the head and the thread so that the belt hardware 
would swivel on the bolt.

   Jimmy.

moparbikeguy@xxxxxxx wrote:

> Can anybody tell me the size and thread of the factory installed nuts that are welded to the underside of the floor for the front seat belts? I want to install belts and will need to buy or make bolts.
>
>
> '65 Coronet 500 stroker
>
> [Non-text portions of this message have been removed]
>
>
> ----
> Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
>
>
>
>  


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.