RE: poly to 5.9L??

["Gary H." <62to65mopar@xxxxxxxxxxx>]

I've not done this swap, but I suspect the same or very similar issues 
would apply for putting an older 360 into a 318 poly equipped car, for 
example, the torque converter balanced for the 360, Lokar carb linkage, 
Schumacher mounts....

Gary H.      


dietz diggler wrote:
> anyone swapped in a 5.9L magnum in place of a poly 318
> bolted to the pushbutton trans? what issues did you
> run into w/ water pumps, TQ conv./flex plate etc. etc.
> i would be going w/ a carb if i decide to do it.
> really just kicking around ideas... (its a 64 polara)
> thanks for any input.
> Sean Dietz 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.