Clarification of Part needed for Polara convert
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Clarification of Part needed for Polara convert



Hi,

The part I need is a convertible only part and covers the lifting 
mechanism (cylinder, linkages etc.).

The rear seat in a convert is narrower than a sedan or hardtop due to 
the mechanism for the roof and a special panel is used to hided 
everything.

>From photos I have received, I think that the 63-65 B body converts all 
use the same piece.  

The armrest is also a particular piece looking more like a hockey stick 
and not at all like the door armrest and bases that has been referred to 
in the replies to my earlier post.  

I mentioned the armrest as a separate item but likely if I can find a 
panel, it will have the armrest on it.

Please check your stockpiles to see if you have this piece.  If you 
don't can you recommend someone that might.

Thanks very much.

K.


Kevin R. Merkley
Thunder Bay, Ontario
64 Dodge 440 2dr HT (Cdn)
64 Dodge Polara 500 convert (Cdn)


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.