Re 64 fury turn signal problem

[Doug & Beth <dickens@xxxxxxxxxxxxx>]

Butch    The problem is most likely the switch itself. At the connector below dash is where you need to test. Find the feed from the flasher by test light . It will be the only on blinking no matter where the switch is positioned. Next test for an blinking on other wires with switch in right turn mode. There should be 2 wires+ flasher blinking . If not the switch or wiring to it is bad. Most times you can pry off the cam and clean each contact. Quite often the cam is not holding down tight [ warped cam will do this from heat] enough to make full contact on each terminal.  

  Doug B.
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.