brake line adapter

[moparbikeguy@xxxxxxx]

I?am looking for the adapter fitting that screws into the rear of a Mopar master cylinder. The "master cylinder adapters" that I find at the local auto parts seem to be too short. They don't seal all the way down before the "hex head" bottoms on the master cylinder. It should adapt 1/4" inverted flair tubing so I can run to my "T" and then 3/16" to the front brakes. If anyone can tell me where they are available, I would appreciate it. 




'65 Coronet 500 stroker

________________________________________________________________________
Check Out the new free AIM(R) Mail -- Unlimited storage and industry-leading spam and email virus protection.

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.