I don't know of a gasket, but you can make small block-off plates from coffee can tops and the like. That's what I did.Just sandwich them in when you install the intake. -- Darwin/BC Canada '65 Cdn.Val'vert 170/A833...eternal project '67 Dart GT'vert 273/904...now with "Collector" status Quoting David orr <fe2orr@xxxxxxxxxxxxxx>: > > > Intake manifold on 426 W keeps burning the paint at the heat crossover. > anyone know if they make a gasket to block off as I do not need any more heat > in Flroida dave O > [Non-text portions of this message have been removed] > > > ---- > Please address private mail -- mail of interest to only one person -- > directly to that person. I.e., send parts/car transactions and negotiations > as well as other personal messages only to the intended recipient, not to the > Clubhouse public address. This practice will protect your privacy, reduce the > total volume of mail and fine tune the content signal to Mopar topic. > Thanks! > > '62 to '65 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html. > > > I don't know of a gasket, but you can make small plates from coffe-can tops or similar to do the same job. That's what I did. ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.