George's engine install & ???'s
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

George's engine install & ???'s





Rich Kinsley  '64 Polara 4 dr 318poly w/goodies

Today we got George's 426 wedge and 4 speed trans in the car. There are 
some issues with the motor mounts though. The problem is that the engine 
sets angled with the trans tail off towards the drivers side rear a 
little. We fought to get the mounts in their K-frame towers. 

I was thinking that there were only /6 and v-8 K-frames, not big block 
and small block. Is this correct? If so it seems the engine mounts 
(insulators?) need to be a little different between the big blocks and 
small blocks. The drivers side needs to be moved back a little, about 
3/4" maybe. I have a set of big block adapters for my '64 B-body from 
Schumachers. I was looking at them and they look exactly right for his 
install BUT his engine came out of his car as I recall so they should be 
OK. I'd bet anything though that the mount adapters I have would cure 
his problem. Any ideas?


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.