Re: Torque setting on front end

[Jason Chance <j23@xxxxxxxxxxx>]

130 ft/lbs was the number that I found.

Jason



Greg Parsons wrote:

> Jason,
>
> It's a 63 sport fury.
>
> Thanks,
> Greg
>
>
> Jason Chance wrote:
>
> > What car? I have a couple manuals I can look it up in...
> >
> > Jason
> >
> > Greg Parsons wrote:
> >
> > > Hey guys,
> > >
> > > I am putting the lower control arms on tonight, so I dug out the 
> > > sheet I have that has the torque setting on it, well I am confused 
> > > now. In one place it says Control Arm (Lower) Shaft Nut 180 pounds, 
> > > then farther down the page it says Lower Control Arm Shaft Nut 130 
> > > pounds.... OK, so which one is right? Or am I reading this wrong and 
> > > these are two different places on the lower control arm?
> > >
> > > Greg
>
>
> ----
> Please address private mail -- mail of interest to only one person -- 
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will 
> protect your privacy, reduce the total volume of mail and fine tune 
> the content signal to Mopar topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

http:///u/?.. 
Or send an email to: 1962to1965mopars-unsubscribe@


http:///?p=