Re: Big Block Cradle

[Doug Ahern <D170A833@xxxxxxxxxxxxxxxxxxx>]

made my cart from bed rail "L" rails (hard steel) and a 19" rack
computer surplus tray.  I get casters from "Big Lots"  for $2 or $3
a piece..  I have one that bolts to the mount ears up front and one 
that bolts to the lower bellhousing bolts in the rear.  supports 
a fully assembled B/RB and can rolled around.   all mig welded up.

another cart  I have is a just a flat rolling shelf with the 
same Big Lots casters,,  it holds two bare blocks standing 
upright so I can roll them under a shelf in the garage.  
I run a 12" chain between the two blocks so the block won't 
try to move when I'm  rolling them around.  the shelf is more or 
less  a "deck" made outta 2x8"s and some strong
pallet wood.  another cart I have holds 4 833s and rolls under a shelf
too.,,  thats a pallet with casters (big lots..).  the pallets I
use are what the 500-600 pound computers are shipped to my office on.
next cart will be a 8-3/4" chuck cart to load up 4 or so and roll 
under a shelf too...


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

http:///u/?.. 
Or send an email to: 1962to1965mopars-unsubscribe@


http:///?p=