dash wire harness
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

dash wire harness



Its time for the dreaded cowl repair on the 64 plymouth wagon.  I want 
to yank the front window and the dash to get at it. BUT- I want the
thing to stilll drive so I can moive it around the shop.
   Whats the minimum number of wires i need to have hooked up in the
   dash harness to start and drive it??
   I know that the ignition switch needs to be in there of course but
   does it need grounded out or can it just dangle.
     and then secondly, the wires going into and out of the ammeter need
     hooked together correct?
    anything else?? I dont want to fry anything and I am a lousy
    electrician.
   Neal zimmmerman, eugene oregon

-- 
http://www.fastmail.fm - The way an email service should be


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@








Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.