rear suspension

[moparbikeguy@xxxxxxx]

 I removed all of the rear suspension and the entire third member today in preparation for putting the springs into the frame rails of my '65 Coronet. I have the superstock springs that are now manufactured in Mexico. I noticed when I installed them earlier this year and again upon removing them today, that the perches are at slightly different angles. The housing perches are exactly the same. I have been using the superstock front spring hangars also. Is this the way they are supposed to be? It seems that the housing would be under a constant twisting. The springs have the right numbers. I got them through Mancini along with the hangars.
 
'65 Coronet 500 stroker
________________________________________________________________________
Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection.

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@