Hi, I had my front and rear windows removed and installed before painting and I reused the rubber gaskets. I had the glass guy look at the gaskets and he said that they were okay to be reused. The trim clips for the front and rear windows are screwed down prior to the gasket installation. Once you remove the windows and gaskets, the clips will be easily accessible and replaced if required. K. Gary Futrell wrote: > > The rear window and windshield gaskets will have to be replaced if > removed. If you're talking about side moldings, they are attached > with clips that break easily and are hard to find. > > > Gary F. > > > > > On 10/16/06, Jim Jablonski <jim@xxxxxxxxxxxxx> wrote: > > > > Thanks to all who responded. Maybe it's because I buried it in the > > wordy post, but what about the winshield and rear window gaskets? Must > > each be replaced when the glass is removed? And what about the moldings > > ... are they connected with clips? > > > > Thanks and regards, > > > > Jim Jablonski > > Royal Oak, Michigan > > '64 Fury > > > > > > Kevin R. Merkley Thunder Bay, Ontario 64 Dodge 440 2dr HT (Cdn) ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx bSONJP. Or send an email to: 1962to1965mopars-unsubscribe@